AIDA
GELINA
BRIKEN
nToF
CRIB
ISOLDE
CIRCE
nTOFCapture
DESPEC
DTAS
EDI_PSA
179Ta
CARME
StellarModelling
DCF
K40
AIDA
Draft saved at 00:00:00
Fields marked with
*
are required
Entry time:
Thu Dec 10 04:56:08 2015
Author
*
:
Subject
*
:
<p>08/12/15 - Day 0.5</p> <p>Test fitted new snout to snout base</p> <p> - the holes in the base of the just-shipped section all line up with those in the corresponding part just taken off.<br /> <br /> - however, the raised corners of the rear metal plate (around the rods), which sits in the downstream end of the Al section of the snout now presents a conflict.<br /> <br /> - the old snout sat inside the raised section but, now that the side length of the snout has been increased, there is a conflict between the snout and the raised portion (see attached photos), which means the snout will not seat properly in the base section.</p> <p> </p> <p>Checked for electrical connection between cooling crate and FEE mezzanines</p> <p> - connection present in all FEEs with resistance < 2 Ohms for most, and the maximum at 1 kOhm for one of the FEE modules.</p> <p> </p> <p>09/12/15</p> <p>Moved AIDA back into rough experimental position, re-cabled setup and powered on complete system.</p> <p>Chiller levels ok, no leaks after ~1hr of operation. Temperatures all remained low and stable.</p> <p> </p>
Encoding
:
HTML
ELCode
plain
Suppress Email notification
Resubmit as new entry
Attachment 1:
2015-12-08_16.19.16.jpg
Original size: 3264x2448
Attachment 2:
2015-12-08_16.16.30.jpg
Original size: 2368x3200
Attachment 3:
Drop attachments here...
Draft saved at 00:00:00
ELOG V3.1.4-unknown