AIDA
GELINA
BRIKEN
nToF
CRIB
ISOLDE
CIRCE
nTOFCapture
DESPEC
DTAS
EDI_PSA
179Ta
CARME
StellarModelling
DCF
K40
AIDA
Draft saved at 00:00:00
Fields marked with
*
are required
Entry time:
Wed Apr 2 01:41:39 2025
Author
*
:
Subject
*
:
MSL type BB18-1000 2998-22 bias +200V I_L +3.52uA Detector bias CAEN N1419 Programmable HV Power Supply - FAGND isolated from AGND (AGND = NIM chassis ground) - floating HV supply, <5mV pp noise specification - configured + polarity, i.e. core to nnaida11 & nnaida12 MSL type BB18 n+n ohmic strips braid to nnaida12 & nnaida13 MSL type BB18 p+n junction strips - configured bias voltage to 200V, max bias voltage 200V, max leakage current 20uA, trip 10s, ramp up/down 1V/s BNC PB-5 amp 0.5V atten x1 tau_d 1ms freq 100Hz pol - (output split via EG&G Ortec 433A to generate + polarity too) PSU Standard AIDA FEE64 PSU + new filter PCBs Adaptor nnaida11 & nnaida12 - polarity input (n+n ohmic strips) MSL type BB18 adaptor PCB rev 180713 LK 3 & 7 nnaida13 & nnaida14 + polarity input (p+n junction strips) MSL type BB18 adaptor PCB rev 290114 LK 1, 3, 5 & 7 +/- test inputs terminated by 50 Ohm DSSSD grounded locally at nnaida12 & nnaida13 adaptor PCBs by ground links LK 1 & 5 Adaptor PCB grounds connected by thick copper braid (see attached images) FEE64 nnaida11 2b:09:ce nnaida12 2b:09:e8 nnaida13 2b:09:07 nnaida14 2b:22:55 FEE firmware release 0x16cee018 ASIC parameters Default ASIC parameters (EXPERIMENT/AIDA/2014Aug13-13.44.58) except - shaping time 2us - slow comparator 64 (hex 40) - nnaida11 & nnaida12 preAmp reference 0x30 -> 0x38 which will reduce linear output range but significantly stabilises negative polarity input ASICs Typical pulser peak widths for nnaida11, 12, 13 and 14 c. 130-150ch FWHM. Without the copper braid connecting the two adaptor PCBs the peak widths are typically 200-250ch FWHM. The problem observed last week (leakage current > 20uA, bias c. 3V, i.e. an apparent 150k short) was found to be due to a fault on the n+n side FEE Adaptor PCB rev 290114. Specifically the left hand connector was faulty. The exact nature of the fault has not yet been determined but will be investigated. For time being the rev 290114 PCB has been replaced by a rev 180713 PCB with a 2-way IDC connector from the HV cable (core) to LK1.
Encoding
:
HTML
ELCode
plain
Suppress Email notification
Attachment 1:
Drop attachments here...
Draft saved at 00:00:00
ELOG V3.1.4-unknown