AIDA
GELINA
BRIKEN
nToF
CRIB
ISOLDE
CIRCE
nTOFCapture
DESPEC
DTAS
EDI_PSA
179Ta
CARME
StellarModelling
DCF
K40
AIDA
Draft saved at 00:00:00
Fields marked with
*
are required
Entry time:
Mon Mar 27 03:28:53 2017
Author
*
:
Subject
*
:
Clock settings for this experiment are slightly different than in the previous case. Below are strictly the settings for the waveform generator itself. Sent to AIDA side: 0 to 5 V amplitude, 50 MHz frequency Sent to BRIKEN side: 0 to 5 V amplitude, 25 MHz frequency Thus, both teams are taking TTL-type signals. However, the BRIKEN one goes to the Philips module which essentially converts it straight away to NIM. There may have been a slight misunderstanding yesterday about the setup, but finally the waveform signal going to BRIKEN was checked and there was no problem. So we don't make any changes (e.g. changing the waveform generator to a NIM-type output).
Encoding
:
HTML
ELCode
plain
Suppress Email notification
Resubmit as new entry
Attachment 1:
Drop attachments here...
Draft saved at 00:00:00
ELOG V3.1.4-unknown