AIDA
GELINA
BRIKEN
nToF
CRIB
ISOLDE
CIRCE
nTOFCapture
DESPEC
DTAS
EDI_PSA
179Ta
CARME
StellarModelling
DCF
K40
AIDA
Draft saved at 00:00:00
Fields marked with
*
are required
Entry time:
Sat Mar 29 12:28:23 2025
Author
*
:
Subject
*
:
> > 09:33 DAQ still running, file R4_11. > Bias/leakage ok (attachment 1) > > Leakage currents whilst still acceptable are up around 400nA on yesterday > Have checked all detectors and rates and pulser peak widths are still good across the board > Will keep an eye on but for now it appears to be ok > BRIKEN is currently doing a Cf source test so could be a result of charging from the source > > Humidity: 33.1, Temperature: 24.6, Dew point: 7.1 > FEE temperatures ok (attachment 2) > > 09:38 System wide checks ok > > 10:25 Pulser peak widths all checked > Widths comparable to 26th apart from 24 which is much wider from ~70 -> ~120 > Waveforms, layout 7 and 8 - attachments 3 and 4 > > 10:37 Started new run on file R5 at time 10:37 > Threshold changed back to 100 from 10 > Pulser on at 2Hz > > 16:34 Stopped R5 alpha run > Lowered thresholds to 0xa to produce higher rate data to test AIDA<->BRIKEN synchronisation > Started file R6 to do this > DAQ crashed on start ASIC readout with unable to connect to nnaida19 message appearing. > Could not clear despite attempts at restarting the merge if that was the cause. > > FEE power cycle > > 17:03 DAQ recovered, R7 started > AIDA did not crash > BRIKEN started Ge fill cycle > AIDA did not crash during or after > > 17:17 R7 Stopped sync program is being worked on by Jorge, > > 17:32 Thresholds raised back to 100 from 10 > Pulser switched off > R8 started > leakage current dropping down (attachment 5)
Encoding
:
HTML
ELCode
plain
Suppress Email notification
Attachment 1:
Drop attachments here...
Draft saved at 00:00:00
ELOG V3.1.4-unknown