AIDA
GELINA
BRIKEN
nToF
CRIB
ISOLDE
CIRCE
nTOFCapture
DESPEC
DTAS
EDI_PSA
179Ta
CARME
StellarModelling
DCF
K40
CARME
Draft saved at 00:00:00
Fields marked with
*
are required
Entry time:
Fri Apr 4 17:18:03 2025
Author
*
:
Subject
*
:
<p>06:20</p> <p>Servo motors moved to fully out position as some work on the beam was neccessary. Beam injection had dropped from ~9e7 to around 1e7. Potentiometer reads 19.10 mm. </p> <p>Still trying to improve target density. Current setpoint 100 K.</p> <p>Merger OK</p> <p>Data rate = 1600 kb/sec</p> <p>Leakage current = 3.21 uA</p> <p>System checks OK - wr fails</p> <p> Base Current Difference<br /> aida01 fault 0xab60 : 0xab8e : 46 <br /> aida02 fault 0x88d3 : 0x8900 : 45 <br /> aida03 fault 0x23aa : 0x23d8 : 46 <br /> aida04 fault 0x15d7 : 0x1605 : 46 <br /> aida05 fault 0x2f03 : 0x2f0f : 12 <br /> White Rabbit error counter test result: Passed 0, Failed 5</p> <p>Understand the status reports as follows:-<br /> Status bit 3 : White Rabbit decoder detected an error in the received data<br /> Status bit 2 : Firmware registered WR error, no reload of Timestamp<br /> Status bit 0 : White Rabbit decoder reports uncertain of Timestamp information from WR</p> <p>Avg ring pressure = 4.3E-10 mbar.</p> <p>06:40</p> <p>Target density still very low. Setpoint back to 116 K. Detectors still fully out, very low rutherford rate.</p> <p>Attempted to move nozzle to increase density, already on maximum point. </p> <p>06:50</p> <p>Setpoint to 95 k. Small increase in target density, however this was temporary</p> <p> </p>
Encoding
:
HTML
ELCode
plain
Suppress Email notification
Attachment 1:
Drop attachments here...
Draft saved at 00:00:00
ELOG V3.1.4-unknown