20:25
Observed short burst of low energy noise on aida1, lasted <30s (attachment 8).
Temperature setpoint = 113 K
Target density OK S1 vaies between 2E-8 and 3E-8 mbar, E4 between 1E-9 and 1E-8 mbar.
Detector moving well between 23.1 mm and 67.43mm, move in and move out counters the same. Correlation scalar on aida1.
Rutherford peak varies between 10^3 and 10^2 depending on detector position, noise peak varies with detector position -> lower further in.
Beam intensity ~1E8
Merger OK
Data rate ~ 1900 Kb/sec
Leakage current = 3.208 uA
Temperatures OK
System checks - wr fails
Base Current Difference
aida01 fault 0xab60 : 0xaba4 : 68
aida02 fault 0x88d3 : 0x8915 : 66
aida03 fault 0x23aa : 0x23ee : 68
aida04 fault 0x15d7 : 0x161b : 68
aida05 fault 0x2f03 : 0x2f20 : 29
White Rabbit error counter test result: Passed 0, Failed 5
Understand the status reports as follows:-
Status bit 3 : White Rabbit decoder detected an error in the received data
Status bit 2 : Firmware registered WR error, no reload of Timestamp
Status bit 0 : White Rabbit decoder reports uncertain of Timestamp information from WR
Avg ring pressure = 5.5 E-10 mbar. Ring pressure tends to oosciilate between ~4 and 5.5 E-10 mbar
21:21
Burst of noise not observed again
Temperature setpoint = 113 K
Target density OK S1 vaies between 2E-8 and 3E-8 mbar, E4 between 1E-9 and 1E-8 mbar.
Detector moving well between 23.1 mm and 67.43mm, move in and move out counters the same. Correlation scalar on aida1.
Rutherford peak varies between 10^3 and 10^2 depending on detector position, noise peak varies with detector position -> lower further in.
Beam intensity ~1E8
Merger OK
Data rate ~ 1900 Kb/sec
Leakage current = 3.206 uA
Temperatures OK
System checks - wr fails
Base Current Difference
aida01 fault 0xab60 : 0xaba4 : 68
aida02 fault 0x88d3 : 0x8915 : 66
aida03 fault 0x23aa : 0x23ee : 68
aida04 fault 0x15d7 : 0x161b : 68
aida05 fault 0x2f03 : 0x2f20 : 29
White Rabbit error counter test result: Passed 0, Failed 5
Understand the status reports as follows:-
Status bit 3 : White Rabbit decoder detected an error in the received data
Status bit 2 : Firmware registered WR error, no reload of Timestamp
Status bit 0 : White Rabbit decoder reports uncertain of Timestamp information from WR
Avg ring pressure 5.4E-10 mbar |