AIDA
GELINA
BRIKEN
nToF
CRIB
ISOLDE
CIRCE
nTOFCapture
DESPEC
DTAS
EDI_PSA
179Ta
CARME
StellarModelling
DCF
K40
CARME
Draft saved at 00:00:00
Fields marked with
*
are required
Entry time:
Fri Apr 4 17:18:17 2025
Author
*
:
Subject
*
:
10.00 Outflow manifold returned from workshop with leaking attachment point welding re-worked. 11.30 Outflow hoses re-attached to outflow manifold. Faulty male Swagelok replaced. Outflow manifold tested on floor - no leaks observed. Mounted outflow manifold. All inflow/outflow hoses attached to FEE64s - see attachments 1-4. FEE64 #11 detached adaptor PCB - temporarily secured by cable tie. Inflow/outflow valves opened. Pin hole leak observed at 3/8" connector gasket - indicated by arrow attachment 3. Leak fixed by tightening fitting. 1x spare inflow/outflow connected together - attachment 4. 11.40 CARME IE514 3.8e-11mbar, ambient temperature 16.5 deg C 15.05 8x AIDA FEE64 power cables ( #1 - #8 ) installed FEE64s #1 - #8 Note - Samtec lock clips broken on 3 of 8 cables due to careless handling/poor storage AIDA FEE64 power cables tied to one of the FEE64 copper coolant pipes. See attachments 5-7 15.30 USB-controlled ac mains relay - USB connected to RPi CARMEbakingpi currently used for CAEN N1419ET Rear panel key switched to override - no flow/d.p. sensors currently installed - front panel water ( yellow ) and override ( red ) LEDs active. 16.15 Transfer CARMEbakingpi from CRYRING network to AIDA 24-port Gbit network switch connected to carme-gsi CARMEbakingpi becomes nnrpi1 p- can connect OK via ssh from carme-gsi Start server ( port 8015 ) manually ssh pi@nnrpi1 /MIDAS/Tcl/Httpd/linux-arm/Tcl-Httpd-server & See attachment 8
Encoding
:
HTML
ELCode
plain
Suppress Email notification
Attachment 1:
Drop attachments here...
Draft saved at 00:00:00
ELOG V3.1.4-unknown