ELOG CARME

AIDA GELINA BRIKEN nToF CRIB ISOLDE CIRCE nTOFCapture DESPEC DTAS EDI_PSA 179Ta CARME StellarModelling DCF K40

CARME

Fields marked with * are required
Entry time:	Mon Mar 31 13:05:54 2025
Author*:
Subject*:
> Continued to mount flanges as per previous ELOG entry. > Peter also remarked that the wires look a bit loose inside the holes, although this is how they were during > dirty tests in Edinburgh. > > Attempted to pack the wires in two holes rather than 4 - too tight. Cannot close. > Packed the wires in 3 holes instead. Better, but still a bit loose. Wire harness feels quite robust and no > obvious strain is placed on the connectors. > > #1 flange left with four strands for now. > Connectors were tested in this way in Edinburgh for motion tests. No broken cables after several thousand > repetitions. > > Had troubles with second flange being mounted. Glove was caught under MACOR connector. Managed to free it > somehow with a cleaned screwdriver. Other half of the flange refused to go in due to bent pins, until NB was > able to repair it. > Mounted as #5. > > Most other connector pins OK. Had to adjust a very small number. Cause of damage unclear - transportation? See > photos. > > Took some pictures inside the chamber. Most connectors look OK, but > > - One harness is touching the NEG wires (#2). This could be an issue. Will try to move it tomorrow > - Wires hanging from the top may be putting a lot of weight on the connectors. See pictures. Given number of > wires this may be acceptable. > - One harness is touching the NEG cage. Definitely an issue. Will fix tomorrow > > Top/bottom flanges mounted with short harnesses. Side flanges mounted with long harnesses. > > Two flanges left to mount. > Only #1 has been tightened. Other flanges left finger tight for Grossmontage to tighten properly tomorrow. > > Outside motor to be fixed tomorrow. Encoding: HTML ELCode plain Suppress Email notification

Attachment 1:
Drop attachments here...

ELOG V3.1.4-unknown