ELOG DESPEC

AIDA GELINA BRIKEN nToF CRIB ISOLDE CIRCE nTOFCapture DESPEC DTAS EDI_PSA 179Ta CARME StellarModelling DCF K40

DESPEC

Fields marked with * are required
Entry time:	Sat Mar 29 11:32:29 2025
Author*:
Subject*:
> The n+n FEEs were all removed to adjust the platform back to the single configuration > > After some confusion we found the orientation of the frame to position the single detectors and moved back > > Faulty AIDA cards aida05 and aida14 were removed to be returned backi (ASIC damage) > > The cables for aida10 and aida12 were moved back to the left-right side and the n+n cards were installed and reocnnected > > p+n cards moved to bring aida11 and aida09 above aida03/aida07 and aida01/aida05. Also move a different card to replace old aida05 > > While doing this it was noticed the HDMI for aida13 was very loose and actually fell off (I guess the cable was pulled incorrectly) > It has been removed and will eb sent back to be resoldered > > The copper grounding bars and ITEM frame were removed due to conflicting with the single snout layout > The bolts are slightly too short to hold the frame where it won't conflict so we loko for longer bolts to reattach the system > Some new ground cables will be made to reach the extra n+n FEEs > > Aida13-Aida16 removed from the PSU > > fig1: layout of snout frame in "single" mode (alu block configuration) > > > MAC Addresses > > aida01 - ba-8a > aida05 - 0d:15 > aida09 - ee-01 > > aida04 - f6-b7 > aida08 - ba-2b > aida12 - ba:89 > > aida03 - d8-21 > aida07 - 41:b4:0c > aida11 - f6-5a > > aida02 - ba:22 > aida06 - ee:72 > aida10 - cf-ac [mistakenly swapped with aida12] > > Second switch will stay in S4 and has now been screwed in properly below the switch 1 and the hdmi cables entrance > > DHCP not updated > > Relay is powered off so FEEs cannot be turned on, alL HV channels disabled > > Tomorrow is a holiday so no work will be happening @ GSI Encoding: HTML ELCode plain Suppress Email notification

Attachment 1:
Drop attachments here...

ELOG V3.1.4-unknown