ELOG ISOLDE

AIDA GELINA BRIKEN nToF CRIB ISOLDE CIRCE nTOFCapture DESPEC DTAS EDI_PSA 179Ta CARME StellarModelling DCF K40

ISOLDE

Fields marked with * are required
Entry time:	Mon Aug 18 06:40:40 2025
Author*:
Subject*:
> This log entry contains a basic instruction on how to operate the Julabo liquid flow chiller. > > There are 5 buttons (left to right): Up/Down, Enter, 1/0. > > To toggle power to the device, use 1/0 (on/off). NB: This only turns the electronics on, and does not initiate circulation / cooling. > > When switched on, it will display sequentially some basic information sequentially. One may generally ignore these, and wait until it displays the current temperature. > > To adjust or check the set point, tap either of Up/Down. To change the set point, press and hold either up or down. Release the button when the desired set point is reached, > and tap up/down to do the fine tuning. > > Once the desired set point is entered, the display will return to the current temperature reading. > > To turn on circulation / chilling, press and hold Enter (the down/left facing arrow). One needs to hold this button several seconds. It is obvious when it begins to operate, as > it will make more sounds, and additionally the Snowflake LED indicator should turn on (unless the current temperature is lower than the set point, it may simply flash briefly). > > The set point can be adjusted while the circulation / chilling is on, as above. > > To turn the circulation / chilling off, hold down Enter again for several seconds. > > Best to raise the set point to ~20 degrees and wait for it to reach the value, before turning off circulation, and finally the device (0 button). Encoding: HTML ELCode plain Suppress Email notification

Attachment 1:
Drop attachments here...

ELOG V3.1.4-unknown