Needed to run startx and start the TcLHttpd server on rpi
Following along here: https://elog.ph.ed.ac.uk/AIDA/242
Can now access http://nnrpi1:8015/AIDA/Rly16/
Window at first connection reads:
Using /dev/ttyUSB0 firmware version 0
Using /dev/ttyUSB1 firmware version 0901
Looks good. Sequence ALL On was selected
(By mistake, I then clicked Relay # to turn off...misread instructions...Switch all OFF, then sequence ALL on again)
7:51 they are turned on. Waiting several minutes now.
Add 4 L of water to the chiller
8:12
Save/Control Settings from Hardware Control tab:
Selected: 2016Jun13-00.53.55 and Restore. (missing from elog 242)
From Run Control, Enable Histogramming, Data Transfer: Enable #1 All (missing from elog 242)
TapeServer / Merger / Httpd started on Workspace 2
TapeServer reports
Cannot issue more Access Tokens: Claim TapeServer returned:- 3 Capability table is full
Make a new directory for storing test data: /data10/TapeData/July2016
Merger: Setup and configure
Data Statistics shows about ~5 x 10^5 events in many nnaida. Should we use a different setting file?
Now we try 2016Jun12-10.10.08
Perform ReSync
Probably event rate can be high because the SSD bias is off? We set up Putty and turn on all biases to -100 V.
Attachments 1 and 2 show the bias settings after they are turned on.
Good Events rate improves, factor 2 to 4 (now about 100k roughly)
Pulser settings: around ~900 on dial, attenuator x10, x10, x2 switches down, 5x up. Frequency ~250 Hz
21:19
Now we change the Control ASICs (select act on all ASICs, act on all FEEs)
Slow Comparator from 0x8 to 0x20
LEC/MEC Fast Comparator 0x4 to 0x80
Now the Good Events go down to about 10k to 25k roughly
TapeServer starts a run.
Merger started / paused / unpaused
Merger rate is 500k / sec. TapeServer is 4 k / sec.
AIDA Syncs shown in Attachment 3
Temps in Attachment 4
Good Events Attachment 5
Run Number 1
Setting file: 2016Jul05-21.37.20 (Note: I wrote the wrong setting file name last night...this is the right one!)
Show sample pulser peak in Attachment 6, 7, 8
July 6 - 12:29: Stop the run. 114 run files, 2.0 GB each.
Attachments 9, 10 show biases at the end of the run |