10.41 DAQ continues OK file RIBF147/R2_352

      100Sn setting, no degrader

      ASIC settings 2019Jun13-08.56.35
      DSSSD#1 slow comparator 0xa -> 0x1d
      DSSSD#3 slow comparator 0xa -> 0x8

      BNC PB-4 Pulser 
      Amplitude 90,000
      x5 attenuator IN
      Frequency 25Hz range, variable min. c. 2.5Hz
      t_r 100ns, tau_d 50us
      - polarity
      Delay MIN, tail pulse

      all system wide checks OK *except* nnaida7 fails ADC calibration

      detector biases & leakage currents OK - see attachments 1 & 2

      FEE64 temperatures OK - see attachment 3

      good event statistics - OK - see attachment 4
      11x <20k 21x < 50k 24x <100k
      Merger OK - see attachment 5
      TapeServer OK - see attachment 6

      p+n FEE64s 1.8.W spectra 20us FSR - attachment 7
      n+n FEE64s 1.8.W spectra 20us FSR - attachment 8
      1.8.L spectra - see attachments 9 & 10
      nnaida1 73 ch FWHM, nnaida3 78 ch FWHM

      FEE64 Rate spectra - attachment 11
      Note high rate issues observed for *some* strips in nnaida14 ASIC #3 & #4 fixed (temporarily) by Check
ASIC Control
      FEE64 Rate spectra - attachment 12

10.58 ADC data synchronised - attachment 13

      Online MIDASsort spectra - attachments 14-18

11.04 analysis of file RIBF147/R2_353 - attachment 19
      deadtime <<1% *all* FEE64s
      no timewarps

11.12 HitRate spectra - attachment 20
      disable nnaida14 *hot* channels 29, 30 & 35 

11.15 zero all histograms
      zero DAQ stats

12.31 DTAS and BigRIPS stop
      AIDA on file R2_368

      DTAS starts file 63
      BigRIPS run 2025
      AIDA file R2_368

13:08 R2_374
      The putty window for USB2 had frozen with a 1 in the voltage set as shown in attachment 1
      The window was no longer updating.
      When regaining the window the voltage limit was applied and the detector
      began to ramp down
      The set voltage was reset to 100V and bias was regained.
      Total time with less than 100V was around 30sec

14:28 DTAS and BigRIPS stop
      AIDA on run R2_386

      DTAS Starts file 66
      BigRIPS run 2026
      AIDA on file R2_387

14:32 Bias and leakage currents ok - attachment 21

15:07 Rate spectra showing no spikes in DSSD 3
      System wide checks

15:08 DTAS and BigRIPS stop
      AIDA onfile R2_393
      BigRIPS chaning slit positions

14:14 DTAS starts file: 
      AIDA on file R2_394
      BigRIPS file 2027 (In control by bigRIPS)

15.30 TAS and BigRIPS stop
      AIDA onfile R2_396