27/05/2025 ca. 6:00
We start a new run: beam is ok, target density ok, detectors are moving in-out periodically.
Cooler voltage setpoint 1105.7 V
Attachment 8 - beamcalc with actual values
Next entry - beamcalc with set values
Right arm at 19.80 mm
Left arm IN at 77.56 mm (OUT 32.53 mm)
vertical beam position 0.0 mm
horizontal beam position -3.5mm
Beam intensity 1.7e+7 particles.
Target density ~6e11 at/cm2
Target temperatures: T1=31.5 K T2=35.2 K
Beam cycle set to 10 seconds.
All check are Ok!
6:30
Noticed a small spike in all leakage currents, see attachment 1
6:50
all checks ok!
07:40
All checks are Ok!
Aida 10 shows sometimes higher statistics.
09:02
All checks are Ok!
Aida 10 shows sometimes higher statistics.
10:00
Checks OK.
Compression works OK.
Moved to run 23. Now moving RIGHT hand side detectors instead of LEFT hand side.
Motion 37.96 mm -> 83.69 mm
Left arm stationary at 18.86 mm
Planning to change energy around lunch.
11:35
Parameters are OK! Tragte density dropped down a bit: ~6e11 at/cm2
12:35
Parameters are OK! Tragte density dropped down a bit: ~1e12 at/cm2
13:10
Starting beam energy change. Detectors OUT. |