F11 plastic has been connected to our dacq as it was in the earlier BRIKEN setting.
The detector cables were followed and connections checked.
The outputs of the detector (L and R) go through an Ortec TFA 474 with the following settings:
Coarse gain: x4
Fine gain: looks minimal
Integrate (ns): 200
Diff (ns): 100
Non-inv setting
After the TFA, the Right signal is plugged in channel 1 of our card, and an attenuated signal (50 Ohm) is
plugged in channel 3. Similarly the Left signal after the TFA is plugged in channel 2 and the attenuated
signal is plugged in channel 4.
Parameters of the channels of the dacq have to be checked.
|